Headphone and speaker test

Play a tone in the left or right channel and check that it comes from the correct side.

Start at low volume.

Channels

Tone generator

The test runs in your browser. Sound, video and key presses are not sent or stored anywhere.

How to run the test

  1. Set the volume low before you start, then raise it to a comfortable level.
  2. Press “Left”, then “Right”. The sound should come only from that side.
  3. Press “Both”: the sound should seem to come from the centre.
  4. Play the sweep from 20 Hz to 20 kHz to hear where the sound disappears or rattles.

Questions and answers

Left and right are swapped

Check that the headphones are worn the right way round and that the speakers have not changed places. If the connection is right, look for a channel swap or a balance setting in the sound settings of the system.

The sound comes from both sides at once

Mono sound is probably turned on in the accessibility settings of the system, or a sound enhancement mixes the channels. With Bluetooth headphones, the headset mode used for calls also plays in mono.

I cannot hear the highest or lowest tones

That is normal. Most adults do not hear above 15–17 kHz, and small speakers barely reproduce tones below 100 Hz. Do not raise the volume to hear them: loud high tones damage hearing even when they seem quiet.

One side is quieter

Check the balance setting in the system and clean the mesh of the earphone. If the difference stays with other devices too, the speaker or the cable is damaged.

Other tests